 |  |  |  |  |  |
Switch and wire.
| | | | | |
Switch and wire.
Here we see the switch in it's place. You need to be careful with this switch. I super glued it to the case. This switch isn't sealed...this means that if you get super glue inside the switch, it will glue the switch in that position! That's why I later on decided to use hot-melt glue...this is handy in that it comes off cleanly if needed. I also used wire-wrap wire for the connection. The advantage is that it is pre-tinned and very small. I connected the wire to the 'common' part of the switch. The other end of this will go to one of the crystal pads (see the next page)