 |  |  |  |  |  |
Crystal image zoomed
| | | | | |
Crystal image zoomed
This is nothing more than the previous image zoomed. Hopefully it isn't too out of focus to help you see how this was placed. One of the things you will notice here (and probably one of the questions you are asking yourself) is that this design is able to use the existing wires to elevate the 3.686Mhz crystal off of the mother board to prevent any shorting. I tested this and pressed down on the crystal to check and there is no problem here! Of course, your placement may require some electrical tape, but it just happened in my case that was not necessary. The only critical piece here was the wire connecting to the other solderpad. It was almost too short. But as you can see, it seems to fit.