 |  |  |  |
Complete
| | | |
Complete
I've laid both halves side-by-side to show that now that I've moved the crystal, it will just miss the door clip. This was troublesome in that I couldn't figure out why when I tightened the screws down, the Newton would fail! Well, now it works flawlessly. All that is needed now is to reassemble the Newt and switch back and forth. I've switched many, many times and I have yet to have an occurance where the switching has caused any problems. I don't know, perhaps I manage to flip the switch precisely between electrons and it works, or perhaps I'm just lucky. If you decide to use my method, I would recommend that you spend plenty of time laying out the parts before you commit them to solder. Working in the tight confines of the newton is not to be done lightly!